{0}------------------------------------------------
||||||
|---|---|---|---|---|
||**SECTION D DETAILS**||||
||||||
||**EMISSION INFORMATION**||||
|**Calculation Method Codes**<br>**(List all that apply)**|**1 = Stack test result**<br>**2 = Material (mass) balance**<br>**3 = EPA approved information (AP-42, CTG, etc.)**<br>**4 =Other (specify intable below)**||||
|**Calculation Rejection Codes**<br>**(List all that apply)**|**1 = Calculation error**<br>**2 = Wrong emission factor(s) used**<br>**3 = Control efficiency(ies) not accepted**<br>**4 =Other (specify intable below)**||||
|**Emission Source (ID No.)**|**Calculation**<br>**Method Code**|**Accept or**<br>**Reject?**|**Calculation**<br>**Rejection Code**|**AB Air Quality**<br>**Calculations**<br>**Attached? **|
|AC1|3,4|NA|NA|Yes|



## **EMISSION NOTES** 

Emissions calculations come from two sources: San Joaquin Valley APCD, and USDA Forest Service. SJV APCD was used for PM, SOx, NOX, CO and VOC, while Greenhouse Gas emissions were obtained from USDA Forest Service. Emissions were also calculated for the engine using AP-42. 

Total emissions included those from the internal combustion engine.
{1}------------------------------------------------
## **SECTION E** 

**SUPPORTING DOCUMENTATION (Provide brief description of any attachments)** 

1. Draft of permit 

2. Emissions estimates prepared by agency staff 

3. Permit application and copy of check for fee 

4. Zoning consistency email 

5. Modeling Memo
